Integra DRX-5.4 User Manual

138
SetupSetup
6. Hardware
 2. Network
Change the settings of the Network function.
• When LAN is congured with a DHCP, set "DHCP" to "Enable" to congure
the setting automatically. ("Enable" is set by default) To assign xed IP
addresses to each components, you must set "DHCP" to "Disable", assign an
address to this unit in the "IP Address" setting, and set information related to
your LAN, such as Subnet Mask and Gateway.
 Wi-Fi (Default Value: Off(Wired))
Connect the unit to the network via a wireless LAN router.
• When switching between "On" and "Off(Wired)", stop the Network service.
Also, when group playback is in process, cancel the group playback once, and
then switch the setting.
On Wireless LAN connection
Off(Wired) Wired LAN connection
 Wi-Fi Setup (Default Value: -)
Congure wireless LAN settings by pressing Enter with "Start" displayed.
 Wi-Fi Status (Default Value: -)
The information of the connected access point is displayed.
SSID SSID of the connected access point.
Signal Signal strength of the connected access point.
Status Status of the connected access point.
 MAC Address (Default Value: -)
Check the MAC address of this unit.
This value is specic to the component and cannot be changed.
 DHCP (Default Value: Enable)
Enable Auto conguration by DHCP
Disable Manual conguration without DHCP
• If you select "Disable", set "IP Address", "Subnet Mask",
"Gateway", and "DNS Server" manually.
 IP Address (Default Value: 0.0.0.0)
Displays/Sets the IP address.
 Subnet Mask (Default Value: 0.0.0.0)
Displays/Sets the subnet mask.
 Gateway (Default Value: 0.0.0.0)
Displays/Sets the gateway.
 DNS Server (Default Value: 0.0.0.0)
Displays/Sets the primary DNS server.
 Proxy URL (Default Value: -)
Displays/Sets the proxy server URL.
 Proxy Port (Default Value: 8080)
Displays/Sets the proxy server port number when you input "Proxy URL".

Integra DRX-5.4 Specifications

General

Brand	Integra
Model	DRX-5.4
Category	Stereo Receiver
Language	English