Advanced Settings (Setup Menu)
En-37
Setting Item Default Value Setting Details
Powered Zone 2 No Set the connection of speakers to Zone 2 speaker
terminals�
"Yes": When speakers are connected to ZONE2
speaker terminals
"No": When speakers are not connected to ZONE2
speaker terminals
● This item will be set to "No" when "Bi-Amp" is set
to "Yes"�
Speaker
Impedance
6ohms Set the impedance of the connected speakers�
"4ohms": When any of the connected speakers have
4 Ω or more to less than 6 Ω impedance
"6ohms": When the connected speakers all have
6 Ω or more impedance
● For impedance, check the indications on the back
of the speakers or their instruction manual�
Crossover
Allows you to change speaker configurations, such as crossover frequency� Settings are
automatically configured if you use the Automatic Speaker Setup� Audio will not be output
while you are making this setting�
● If you are using THX-certified speakers, we recommend the following settings:
– Set a value "80Hz(THX)" in Crossover frequency�
– Set a value "80Hz(THX)" in LPF of LFE�
– Set a value "Off" in Double Bass�
Setting Item Default Value Setting Details
Front 80 Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel�
"Full Band": Full band will be output�
● If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Full Band" and the low
pitched range of the other channels will be output
from the front speakers� Refer to the instruction
manual of your speakers to make the setting�
Setting Item Default Value Setting Details
Center 80 Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel�
"Full Band": Full band will be output�
● "Full Band" can be selected only when "Front" is
set to "Full Band"�
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels�
Height 80 Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel�
"Full Band": Full band will be output�
● "Full Band" can be selected only when "Front" is
set to "Full Band"�
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels�
Surround 80 Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel�
"Full Band": Full band will be output�
● "Full Band" can be selected only when "Front" is
set to "Full Band"�
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels�
To Next Page
Loading...
