Why is there a high-pitched or buzzing noise on AM with my Integra Receiver?
This noise could be coming from a TV set. Try placing the AM loop antenna as far away from the TV as possible, or move the unit away from the TV set.
Why is my Integra DTR-5.1 making a crackling noise on AM and FM?
This could be due to noise from a fluorescent lamp being turned on and off, so move the antenna as far as possible from the lamp. It could also be noise from automobile ignition, so install an FM outdoor antenna as far as possible from the road. You can also try changing the position or direction of the outdoor antenna.
Why is my Integra DTR-5.1 Receiver howling when the volume is turned up?
The turntable and speakers may be too close together. Try moving them farther apart.
Why does my Integra DTR-5.1 Receiver sound rough or scratchy, and the high range isn't clear?
This could be because the stylus of your turntable pick-up is worn, in which case you should replace it. Alternatively, the turntable stylus tip may be dirty, so try cleaning it. Also, check if the treble control is set too high and turn it down if necessary.
Why do the TUNED and STEREO indicators light up, but the sound is distorted, and the stereo separation is bad on my Integra DTR-5.1?
The station signal may be too strong. Try changing to an FM indoor antenna. Alternatively, multiple reflections of radio waves from tall buildings or mountains could be the issue. Use an antenna with better directivity and select a point where the distortion is minimal.
General| Channels | 5.1 |
|---|---|
| Total Harmonic Distortion (THD) | 0.08% |
| Input Impedance | 47 kOhms |
| Audio Formats Supported | Dolby Digital, DTS, Dolby Pro Logic II |
| Video Formats Supported | Composite, S-Video |
| Input Sensitivity | 200 mV |
| Signal-to-Noise Ratio | 100 dB |
| Digital Inputs | 2 Optical, 1 Coaxial |
| Frequency Response | 10Hz - 100kHz |
| Speaker Impedance | 8 ohms |
| Audio Inputs | 5 Analog |
To Next Page
