FIRMWARE UPDATE -2
DTR-5.8
Main Microprocessor Update Procedure
HDMI Update Procedure
2. Click "Video Update" button. The update takes about 5 minutes.
The message on Front Display will change as follows.
3. After the update ends, turn off the unit's main power switch or pull the power cord off the wall socket.
4. Remove the jig from the unit and power on the unit again. Confirm the new version number.
Clear
Complete!
Write: 1..
The unit is put into the Standby mode.
1. Start "FlashSta.exe" and update the unit referring to "Flash Writer M16 Manual.pdf."
MCU Type is M16C/20 62 It takes about 5 minutes.
2. After Program and Read Check are finished, click "Exit" button to end "FlastSta.exe".
3. Turn off the main power switch or pull the power cord off the wall socket.
Pay attention that pushing STANDBY/ON button to power off is not perfect.
4. Remove the jig from the unit and power on the unit again. Confirm the new version number.
1. Double click "Update.exe" in the unzipped folder "HDMIUpdater_SR805_07706A” (Folder name depends on the version.)
The following window will appear.
This information will appear when
the click of [Video Update] is accepted.
The number is going up
as writing is proceeding.
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
Need help?
General
