Why can noise be heard from my Integra Receiver?
If you are experiencing noise with your Integra Receiver, it might be due to interference. An analog audio (RCA) cable may be picking up interference. Try repositioning your cables. Avoid bundling analog audio (RCA) cables with power cords or speaker cables, as this can degrade audio performance.
What to do if the remote controller does not work with my Integra Receiver?
If the remote controller for your Integra Receiver isn't working, ensure it's not too far from the unit and that there are no obstructions between the remote controller and the unit's remote control sensor.
How to fix Integra DTR-50.6 that cannot turn on?
If you can't turn on your Integra Receiver, ensure the power cord is properly connected. If it is, disconnect the power cord for one hour, then reconnect it and try turning the power on again. If the unit turns off again, unplug the power cord and contact your dealer.
What to do if the image input from the composite video input terminal does not get displayed on my Integra DTR-50.6 Receiver?
If the image input from the composite video input terminal does not get displayed, make sure that the component video input terminal is not set to the selected input.
Why does the center speaker produce no sound on my Integra DTR-50.6?
If the center speaker on your Integra Receiver produces no sound, it may be because the Stereo or Mono listening mode is selected. Ensure the speakers are configured correctly.
What to do if there is no sound from surround back speakers, height speakers or wide speakers on my Integra DTR-50.6?
If there is no sound from surround back speakers, height speakers or wide speakers on your Integra Receiver, it may be because, depending on the source or current listening mode, not much sound may be output from speakers. Try selecting another listening mode and make sure the settings for the speakers are made correctly.
How to fix no sound with Dolby Atmos signal format on Integra Receiver?
If there is no sound with Dolby Atmos signal format on your Integra Receiver, make sure the surround back speakers, the height speakers or the wide speakers are connected and configured as connected in the 'Speaker Configuration'. Also, ensure the input signal is in the Dolby Atmos format.
What to do if the surround speakers produce no sound on my Integra DTR-50.6 Receiver?
If the surround speakers on your Integra Receiver produce no sound, it may be because the Stereo, Mono, or T-D (Theater-Dimensional) listening mode is selected. Depending on the source and current listening mode, not much sound may be produced by the surround speakers. Try selecting another listening mode and ensure the speakers are configured correctly.
General| Audio Channels | 7.2 |
|---|---|
| HDMI Inputs | 8 |
| HDMI Outputs | 2 |
| Dolby Atmos | Yes |
| DTS:X | Yes |
| Wi-Fi | Yes |
| Bluetooth | Yes |
| Multi-room Audio | Yes |
| THD (Total Harmonic Distortion) | 0.08% |
| DAC | 32-bit/192 kHz |
To Next Page
