Why does only the center speaker produce sound on my Integra DTR-50.6?
If your Integra Receiver is only producing sound from the center speaker, it may be because you are using the Dolby Surround listening mode with a mono source, such as an AM radio station or mono TV program, which concentrates the sound in the center speaker. Ensure the speakers are configured correctly.
What to do if the surround speakers produce no sound on my Integra DTR-50.6 Receiver?
If the surround speakers on your Integra Receiver produce no sound, it may be because the Stereo, Mono, or T-D (Theater-Dimensional) listening mode is selected. Depending on the source and current listening mode, not much sound may be produced by the surround speakers. Try selecting another listening mode and ensure the speakers are configured correctly.
How to fix no sound with Dolby Atmos signal format on Integra Receiver?
If there is no sound with Dolby Atmos signal format on your Integra Receiver, make sure the surround back speakers, the height speakers or the wide speakers are connected and configured as connected in the 'Speaker Configuration'. Also, ensure the input signal is in the Dolby Atmos format.
What to do if there is no sound from surround back speakers, height speakers or wide speakers on my Integra DTR-50.6?
If there is no sound from surround back speakers, height speakers or wide speakers on your Integra Receiver, it may be because, depending on the source or current listening mode, not much sound may be output from speakers. Try selecting another listening mode and make sure the settings for the speakers are made correctly.
Why does the center speaker produce no sound on my Integra DTR-50.6?
If the center speaker on your Integra Receiver produces no sound, it may be because the Stereo or Mono listening mode is selected. Ensure the speakers are configured correctly.
What to do if the image input from the composite video input terminal does not get displayed on my Integra DTR-50.6 Receiver?
If the image input from the composite video input terminal does not get displayed, make sure that the component video input terminal is not set to the selected input.
What to do if reception is noisy on my Integra Receiver?
If reception is noisy, FM stereo reception is noisy, or the FM STEREO indicator does not light on your Integra Receiver, re-check the antenna connection.
How to adjust speaker volume if it cannot be set as required on my Integra DTR-50.6 Receiver?
If the speaker volume on your Integra Receiver cannot be set as required, check to see if a maximum volume has been set.
Why cannot I get 6.2 ch/7.2 ch playback on my Integra DTR-50.6 Receiver?
If you can't get 6.2 ch/7.2 ch playback on your Integra Receiver, it is because 6.2 ch/7.2 ch playback is not possible if surround back speakers, height speakers and wide speakers are not connected. Depending on the number of connected speakers, it is not always possible to select all of the listening modes.
What to do if there is no picture on my Integra DTR-50.6?
If there is no picture on your Integra Receiver, make sure that all video connecting plugs are pushed in all the way and that each video component is properly connected.
General| Audio Channels | 7.2 |
|---|---|
| HDMI Inputs | 8 |
| HDMI Outputs | 2 |
| Dolby Atmos | Yes |
| DTS:X | Yes |
| Wi-Fi | Yes |
| Bluetooth | Yes |
| Multi-room Audio | Yes |
| THD (Total Harmonic Distortion) | 0.08% |
| DAC | 32-bit/192 kHz |
To Next Page
