To Next PageTo Next Page
Need help?Do you have a question about the Integra DTR-6.5 and is the answer not in the manual?
General| HDMI Outputs | 1 |
|---|---|
| Component Video Outputs | 1 |
| Digital Audio Inputs (Optical) | 2 |
| Phono Input | Yes |
| Bluetooth | No |
| Wi-Fi | No |
| Audio Formats Supported | Dolby Digital, DTS, DTS Neo:6 |
| Total Harmonic Distortion | 0.08% |
| Input Sensitivity | 200mV |
| Signal to Noise Ratio | 100 dB (line) |
| Output Power / Channel | 110W (6 ohms, 1 kHz, 1% THD, 1 channel driven) |
| Video Inputs/Outputs | Composite: 3 inputs/1 output |
| Multi-room Output | Yes (Zone 2) |
Details concerning critical components for fire and electric shock risk.
Procedure for replacing fuses, emphasizing correct type and rating for fire hazard prevention.
Mandatory safety check for leakage current and resistance after service.
Schematic shows input signal paths for various sources like PHONO, CD, TAPE, VIDEO, DVD.
Schematic details the DSP section, output stages, and connections to other diagrams.
Schematic of DSP section showing connections to ADCs, DACs, and filtering stages.
Schematic details the driver circuitry for SL, SR, SBL, and SBR speaker output channels.
Schematic details the power amplifier stages for each speaker channel (L, R, C, SL, SR, SBL, SBR).
Schematic for NAVD-8464 video circuit, showing input multiplexing, decoding (ADV7183A), and output.
Schematic for NADG-8366 microprocessor, including I/O ports, trigger controls, and IR/A-Bus interfaces.
Component side view of the DSP and preamplifier PC board (NAAR-8365).
Soldering side view of the driver circuit PC board (NAAF-8383), showing output transistors and connections.
Soldering side view of the NAAF-8397 power amplifier PC board, detailing component placement.
Soldering side view of the NAAF-8391 power amplifier PC board.
Schematic for the NAPS-8382 primary circuit PC board, including fuses and AC outlets.
Component side view of the NADIS-8406 display circuit PC board.
Soldering side view of the NADIS-8406 display circuit PC board.
Component side view of the NADG-8366 main connector PC board.
Component side view of the NAETC-8367 control terminal PC board.
Block diagram illustrating the internal functions of the ADV7172 video encoder IC.
Diagram showing the pin layout and identifier for the ADV7172 IC.
Block diagram illustrating the internal functions of the ADV7183A video decoder IC.
Diagram showing the pin layout for the 80-lead LQFP ADV7183A video decoder IC.
Procedure for adjusting idling current for front, center, surround, and surround back channels.
Instructions for entering test modes, checking voltage detection, and current detection for protection circuits.
Procedure to check voltage sensor and thermal protector using test modes and resistors.
