What to do if my Integra Receiver has power but no sound?
If your Integra Receiver powers on but produces no sound, first check if the MUTING indicator is lit and, if so, press the MUTING button on the remote to disable it. Also, ensure the correct digital/analog input is selected and verify all connections and speaker leads.
How to troubleshoot no sound from Integra DTR-5 Receiver center speaker?
If you're not getting sound, or very little sound, from the center speaker of your Integra Receiver, check the connection between the amplifier and the speaker. Ensure that the listening mode is not set to STEREO; choose another mode. Make sure the CENTER level isn't set to minimum, and confirm that CENTER SPEAKER is set to LARGE or SMALL, not NONE.
How to fix Integra DTR-5 when it has no power?
If your Integra Receiver has no power, ensure the power cord is securely plugged into the AC outlet and the receiver itself. If that doesn't work, try turning the power off and on again, or unplugging and re-plugging the AC cord to address potential external noise in the circuits.
Why is my Integra DTR-5 Receiver producing a hum or low-frequency noise?
If you are experiencing hum or low-frequency noise with your Integra Receiver, check the outer conductor of the input plugs for a poor or missing ground. Also, verify the ground connection of your phono motor, if applicable. Try adjusting the placement of the audio connection cables on the rear panel to minimize hum.
Why Integra DTR-5 Receiver TUNED and STEREO indicators light but sound distorted?
If your Integra Receiver's TUNED and STEREO indicators light up, but the sound is distorted and stereo separation is poor, try switching to an FM indoor antenna, as the station might be too strong. If the issue persists, especially in areas with tall buildings or mountains, use an antenna with better directivity and find a location where the distortion is minimal.
How to stop Integra DTR-5 Receiver from howling when volume is high?
If you experience a howling sound when the volume is turned up on your Integra Receiver, the turntable and speakers may be too close together. Try moving them farther apart.
Why do Integra DTR-5 TUNED and STEREO indicators flicker with FM hiss?
If your Integra Receiver's TUNED and STEREO indicators flicker and you hear hiss on FM, the station may be too weak. Try installing an outdoor FM antenna. Adjust the position or direction of the outdoor antenna, keeping in mind that stereo FM broadcasts have a shorter range than ordinary broadcasts.
What to do if Integra DTR-5 Receiver remote control not working?
If the front panel controls on your Integra Receiver are working, but the remote controller isn't, first ensure that there are batteries in the remote. If batteries are present, try replacing them, as the old ones may be worn out.
Why does my Integra Receiver have rough or scratchy sound?
If you are experiencing a rough or scratchy sound, or the high range isn't clear on your Integra Receiver, the stylus of your turntable pick-up may be worn. If so, replace it. The turntable stylus tip might also be dirty, so try cleaning it. Also, turn the treble control down.
How to fix Integra DTR-5 if AM stations cannot be received?
If you can't receive AM stations on your Integra Receiver, connect the included AM loop antenna to the AM antenna terminals.
Steps to turn the unit on and off using the main unit or remote.
Configuring speaker presence and size settings.
Adjusting speaker distance from the listening position.
Using test tone to adjust speaker levels for optimal sound.
Choosing between digital and analog audio inputs for sources.
Adjusting individual speaker levels for multi-channel sources.
Explains listening modes, including digital formats and custom options.
General overview and controlling the DTR-5 unit.
How to teach the remote to control other devices.
Removing programmed codes from individual buttons or modes.
Resetting the remote to factory defaults by erasing all programmed data.
General| HDMI Outputs | 1 |
|---|---|
| Component Video Outputs | 1 |
| THD | 0.08% |
| Frequency Response | 10Hz - 100kHz |
| Total Harmonic Distortion | 0.08% |
| Input Sensitivity | 200mV |
| Video Inputs | 4 (composite) |
| Audio Inputs | 4 (analog) |
To Next Page
