Integra DTR-5 User Manual

41
Specifications
AMPLIFIER SECTION
VIDEO SECTION
TUNER SECTION
FM
AM
GENERAL
REMOTE CONTROL
Specifications and features are subject to change without notice.
Power supply and voltage vary depending on the area in which the unit is
purchased.
Continuous Average Power
output (FTC)
All channels: 70 watts per channel min. RMS at
8 ohms, 2 channels driven from 20 Hz
to 20 kHz with no more than 0.08%
total harmonic distortion.
90 watts min. RMS at 6 ohms, 2 chan-
nels driven from 1 kHz with no more
than 0.1% total harmonic distortion.
Maximum Power output (EIAJ) 130 watts at 6 ohms
Total Harmonic Distortion: 0.08% at rated power (Front)
IM Distortion: 0.08% at rated power (Front)
Damping Factor: 60 at 8 ohms (Front)
Input Sensitivity and Impedance
PHONO: 2.5 mV, 50 kohms
LINE (CD, TAPE, DVD,
VIDEO 1, 2, 3): 200 mV, 50 kohms
MULTICHANNEL INPUT
(FRONT L/R, SUR-
ROUND L/R, CENTER): 200 mV, 50 kohms
(SUBWOOFER): 36 mV, 50 kohms
COAXIAL 1, 2 (DIGITAL): 0.5 Vp-p, 75 ohms
Output Level and Impedance
Rec out (TAPE, VIDEO 1): 200 mV, 2.2 kohms
Pre out (SUBWOOFER): 1 V, 2.2 kohms
Phono Overload: 70 mV RMS at 1 kHz, 0.5% T.H.D.
Frequency Response: 20 Hz to 100 kHz, +1/–3 dB
RIAA Deviation: 20 Hz to 20 kHz, ±0.8 dB
Tone Control
Bass: ±10 dB at 100 Hz
Treble: ±10 dB at 10 kHz
Signal-to-Noise Ratio
Phono: 80 dB (IHF A, 5 mV input)
CD/Tape: 100 dB (IHF A)
Input sensitivity/Impedance
(DVD, VIDEO 1, 2, 3)
VIDEO (Composite): 1 Vp-p, 75 ohms
Output Level/Impedance
(VIDEO 1, MONITOR)
VIDEO (Composite): 1 Vp-p, 75 ohms
Tuning Range: 87.5 — 108.0 MHz
Usable Sensitivity
Mono: 11.2 dBf, 1.0 µV (75 ohms)
Stereo: 17.2 dBf, 2.0 µV (75 ohms)
50 dB Quieting Sensitivity
Mono: 17.2 dBf, 2.0 µV (75 ohms)
Stereo: 37.2 dBf, 20 µV (75 ohms)
Capture Ratio: 2.0 dB
Image Rejection Ratio: 40 dB
IF Rejection Ratio: 90 dB
Signal-to-Noise Ratio
Mono: 76 dB
Stereo: 70 dB
Alternate Channel Attenuation: 55 dB
Selectivity: 50 dB (DIN)
AM Suppression Ratio: 50 dB
Total Harmonic Distortion
Mono: 0.2%
Stereo: 0.3%
Frequency Response: 30 Hz — 15 kHz, ±1.0 dB
Stereo Separation: 45 dB at 1 kHz
30 dB at 100 Hz — 10 kHz
Tuning Range: 530—1,710 kHz (10 kHz steps)
Usable Sensitivity: 30 µV
Image Rejection Ratio: 40 dB
IF Rejection Ratio: 40 dB
Signal-to-Noise Ratio: 40 dB
Total Harmonic Distortion: 0.7%
Power Supply: AC 120 V, 60 Hz
Power Consumption: 3.9 A
325 W
Dimensions (W
× H × D): 435 × 175 × 390 mm
17-1/8" × 6-7/8" × 15-3/8"
Weight: 12.2 kg, 26.9 lbs.
Transmitter: Infrared
Signal range: Approx. 5 meters, 16 ft.
Power supply: Two “AA” batteries (1.5 V
× 2)

Integra DTR-5 Specifications

General

Brand	Integra
Model	DTR-5
Category	Receiver
Language	English