Serial Port 6 Configuration
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM).
The optional settings: [Disabled]; [Enabled].
Change Settings
Use this item to select an optimal setting for super IO device.
The optional settings: [Auto]; [IO=3F8h; IRQ=11;]; [IO=2F8h; IRQ=11;]; [IO=3E8h;
IRQ=11;]; [IO=2E8h; IRQ=11;]; [IO=2F0h; IRQ=11;]; [IO=2E0h; IRQ=11;].
Serial Port FIFO Mode
The optional settings are: [16-Byte FIFO]; [32-Byte FIFO]; [64-Byte FIFO];
[128-Byte FIFO].
OS Select for Serial Port
Use this item to select serial port.
The optional settings: [Windows]; [LINUX].
ERP Support
Use this item to select Energy-Related Products function.
The optional settings: [Disabled]; [Enabled].
This item should be set as [Disabled] if you wish to have all active wake-up
functions.
Case Open Detect
This item will detect if case have ever been opened, it will show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enable]; system will detect if COPEN has been short or not (refer to
JAT_COPEN jumper setting for Case Open Detection); if Pin 3&4 of Case Open
are short, system will show Case Open Message during POST.
To Next Page
Loading...
Need help?
General
