PS2 KB/MS Connect
Use this item to select PS2 connect primary device.
The optional settings: [Keyboard First]; [Mouse First].
WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
When set as [Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can select a value in the range of [10] to [255] seconds when ‘WatchDog
Reset Timer Unit’ set as [Sec]; or in the range of [1] to [255] minutes when
‘WatchDog Reset Timer Unit’ set as [Min].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
WatchDog Wake-up Timer
Use this item to enable or disable WDT wake-up function.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
WatchDog Wake-up Timer Value
User can select a value in the range of [10] to [4095] seconds when ‘WatchDog
Reset Timer Unit’ set as [Sec]; or in the range of [1] to [4095] minutes when
‘WatchDog Reset Timer Unit’ set as [Min].
WatchDog Wake-up Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item displays current Emulate AT Power Status, motherboard power On/Off
control by power supply. User needs to select ‘AT or ATX Mode’ on MB jumper at
first (refer to Pin (1&2) of JAT_COPEN for ATX Mode & AT Mode Select).
Serial Port Console Redirection
Press [Enter] to make settings for the following sub-items:
To Next Page
Loading...
