Intel Denverton Series User Manual

25
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not (refer to
Page 8); if COPEN is short, system will show Case Open Message during POST.
WatchDog Reset Timer
Use this item to enable or disable WDT reset function. When set as [Enabled], the
following sub-items shall appear:
WatchDog Reset Timer Value
User can select a value in the range of [10] to [255] seconds when ‘WatchDog
Reset Timer Unit’ set as [Sec]; or in the range of [1] to [255] minutes when
‘WatchDog Reset Timer Unit’ set as [Min].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
► PC Health Status
Press [Enter] to view current hardware health status, or make further settings in
‘SmartFAN Configuration’ and ‘Shutdown Temperature’.
► SmartFAN Configuration
Press [Enter] to make settings for SmartFan Configuration:
SmartFAN Configuration
CPUFAN Smart Mode/SYSFAN Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN/SYSFAN Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN full speed temperature. Fan will run at full
speed when above this pre-set temperature.
CPUFAN/SYSFAN Full-Speed Duty
Use this item to set CPUFAN/SYSFAN full-speed duty. Fan will run at full speed
when above this pre-set duty.

Intel Denverton Series Specifications

General

Brand	Intel
Model	Denverton Series
Category	Computer Hardware
Language	English