Installing and Replacing Desktop Board Components
45
Setting the BIOS Configuration Jumper
NOTE
Always turn off the power and unplug the power cord from the computer before
moving the jumper. Moving the jumper with the power on may result in unreliable
computer operation.
Figure 22 shows the location of the Desktop Board’s BIOS confi
guration jumper block.
Figure 22. Location of the BIOS Configuration Jumper Block
The three-pin BIOS jumper block enables all board configurations to be done in the
BIOS Setup program. Table 13 shows the jumper setti
ngs for the BIOS Setup
program modes.
To Next Page
Loading...
