EasyManuals Logo

Intel DN2800MT Product Guide

Intel DN2800MT
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
Intel Desktop Board DN2800MT Product Guide
50
Table 17. BIOS Speaker Beep Codes
Type Pattern Frequency/Comments
Video error On-off (1.0 second each) two times, then a
2.5-second pause (off), the entire pattern
repeats (beeps and pause) once and the
BIOS will continue to boot.
932 Hz
Memory error On-off (1.0 second each) three times, then
a 2.5-second pause (off), the entire pattern
repeats (beeps and pause) until the system
is powered off.
932 Hz
Thermal trip warning
Alternate high and low beeps (1.0 second
each) for eight beeps followed by system
shut down.
High beep 2000 Hz
Low beep 1500 Hz
BIOS Error Messages
The BIOS may also display an error message on the PC monitor when certain
recoverable error occurs during POST. Table 18 gives an explanation of the BIOS error
messages.
Table 18. BIOS Error Messages
Error Message Explanation
CMOS Battery Low The battery may be losing power. Replace the battery
soon.
CMOS Checksum Bad
The CMOS checksum is incorrect. CMOS memory may
have been corrupted. Run Setup to reset values.
Memory Size Decreased Memory size has decreased since the last boot. If no
memory was removed, then memory may be bad.
No Boot Device Available System did not find a device to boot.

Table of Contents

Other manuals for Intel DN2800MT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intel DN2800MT and is the answer not in the manual?

Intel DN2800MT Specifications

General IconGeneral
BrandIntel
ModelDN2800MT
CategoryMotherboard
LanguageEnglish

Related product manuals