Intel Express 10 User Manual

42
CHAPTER 3 Intel Express 10/100 Fast Ethernet Switch
set-rsw-file
set-rsw-file <filename>
Sets the name of the SNMP agent software remote file for download.
This is the file downloaded from a TFTP server, if you’ve defined
one.
get-tftp-srvr
Displays the TFTP server IP address to be used for downloading
SNMP agent software.
set-tftp-srvr
set-tftp-srvr <IPaddress>
Sets the TFTP server IP address to be used for downloading SNMP
agent software.
sw-dnld
Starts the SNMP software download from the defined TFTP server.
get-par-file
Displays the name of the SNMP agent parameter file.
set-par-file
set-par-file <filename>
Sets the name of the SNMP agent parameter file to be downloaded by
BOOTP. The filename must match the name of the parameter file on
the BOOTP server. The format for the parameter file is:
<switch_hardware_address> : <read_comm> : <write_comm>
Example:
00-A0-C9-00-01-23 : public : private
You can find the switch_hardware_address by using the sys-stat
command (it’s the system MAC address).
set-fg-param
set-fg-param <dest> <source> <fill_byte> <length>
Sets the frame generator parameters. The dest and source are dash-
separated MAC addresses. The
fill_byte is a single byte used to fill
the entire packet except for the first 12 bytes. The
length is the total
length of the packet excluding CRC.

Intel Express 10 Specifications

General

Brand	Intel
Model	Express 10
Category	Network Router
Language	English