47
Console Command Reference
CHAPTER 3
Address Resolution Protocol (ARP)
Commands
get-arp-tbl
Displays the ARP table. The table lists the port and MAC address for
each IP address the switch has communicated with recently.
SYS_console> get-arp-tbl
IfIndex IpAddress MAC Address
====================================================
1 129.001.001.001 00-40-05-2D-73-9C
1 129.001.001.200 00-02-A0-D4-9A-57
add-arp-entry
add-arp-entry <IPaddress> <mac_address> <port>
Adds an entry to the ARP table manually. port is the switch port the
device is connected to.
del-arp-entry
del-arp-entry {<IPaddress>|*}
Deletes entries from the ARP table. If you enter an IP address, the
matching ARP entry is deleted. If you enter
*, the entire ARP table is
cleared.
Use this command if the network topology physically changes. For
example, when a management station moves from one segment to
another and its port number changes.
CAUTION
The del-lt-entry com-
mand is very powerful,
allowing you to change the
entire switching database
with the exception of the
system MAC addresses. Use
it with caution.
To Next Page
Loading...
Need help?
General