Wake on LAN Enable
Use this item to enable or disable integrated LAN to wake the system.
The optional settings: [Enabled]; [Disabled].
Onboard Lan2 Controller
Use this item to enable or disable Device or Controller.
The optional settings: [Disabled]; [Enabled].
MPE Slot
Use this item to enable or disable Device or Controller.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Speed
Use this item to configure PCIe Speed.
The optional settings: [Auto]; [Gen1]; [Gen2]; [Gen3].
System State after Power Failure
Use this item to specify what state to go to when power re-applied after a power
failure (G3 state).
The optional settings: [Always Off]; [Always On]; [Former State].
To Next Page
Loading...
