Intellian FB500 - Page 23

23
Mounting the Antenna
Attach the antenna to the post by using the hex head bolts, spring washers and
at washers, and nut supplied.
After completely applying Loctite 263 to all four Bolt thread, mount or remount the
FB500 Radome.
Radome Base
Deck
M8 Flat Washer
M8 Spring Washer
M8 Hex. Bolt
13mm Spanner
FB250 FB500
Radome Base
Deck
M6 Flat Washer
M6 Spring Washer
M6 Hex. Nut
10mm Spanner
M6 Flat Washer
M6 Hex. Bolt
10mm Spanner
Note: For FB250 with Intelian i4 system, use the hex head bolts (M8x35L), M8 Spring
washers and M8 at washers supplied. In this case, it is recommended to use a 13mm
Spanner. For FB500, apply the Loctite 263 on four M8 Hex Bolts as shown in the picture
below before starting the mounting procedures.
Hex Head Bolt
Spring Washer and
Flat Washer
Nut
FB250 M6 x 35L M6 M6
FB500 M8 x 50L M8
M8 Hex Head Bolts