Need help?Do you have a question about the Intellian V100 and is the answer not in the manual?
General| Frequency Band | Ku-band |
|---|---|
| Polarization | Linear |
| Reflector Material | Aluminum |
| Stabilization | 3-axis |
| Antenna Diameter | 1.0 m |
| Operational Temperature | -30°C to +55°C |
| Wind Survival | 100 knots |
| Type | VSAT Antenna |
Step-by-step instructions for unpacking and installing the antenna unit.
Methods for mounting the ACU, including rack and table types.
Establishes data communication between a PC and the ACU via TCP/IP.
How to enter and exit the system's setup mode for configuration.
Guides initial setup of satellite, location, and gyro type.
Steps to manually search and peak the satellite signal.
Executes diagnostic tests to identify system issues.
Loading, editing, and adding satellite information for tracking.
Selects and loads a satellite for tracking.
Configures LNB frequency, location, modem, and management options.
Selects modem type, port, and protocol for satellite communication.
Steps to install the Aptus software on a computer.
Establishes data communication between PC and ACU via Aptus.
Monitors antenna status, signal, GPS, and software information.
Performs diagnostic tests and configures modem interface.
Remote monitoring and control of v-Series via TCP/IP using Aptus Web.
Login page for Aptus Web, allowing control or monitoring modes.
Quick monitoring of antenna status and settings via dashboard.
Configures ship info, GPS, block zones, and tracking parameters.
Adjusts antenna position, sensor bias, and search parameters.
Sets tracking mode, frequency, and satellite parameters.
Configures modem interface, port, protocol, and parameters.
Upgrades antenna and ACU firmware versions.
Steps for upgrading antenna and ACU firmware.
Configures network, SNMP, user management, and device settings.
Technical performance metrics like frequency, gain, and G/T.
To Next Page
