76
Satellite Selection
The default Satellite Selection is in Auto mode. In Auto mode, the UE will scan all
the visible satellites and track the satellite with
the most optimum elevation angle or the last used satellite.
Note: Changing the satellite selection will terminate any existing active voice/fax
call or data connections.
Follow these steps to change your satellite selection
1. Click on Setup icon
2. Click the Satellite Selection to view the visible satellites.
The visible satellites will be displayed for your selection.
It also displays the satellite information that your Antenna Unit’s is locked on to.
3. Click on your choice of visible satellites.
4. Click the Select button to point the antenna to the selected satellite in exclusive
mode. The satellite selection will be saved, and each time you power up the UE,
the satellite selection choice will remain until you make the next selection change.
The UE will track the newly selected satellite even if the elevation angle is not
optimum.
5. Click Refresh to refresh the Satellite list.
To Next Page
Loading...
