to this mode. This mode is also the default setting.
Though the adapter is compatible with both 802.11g
and 802.11b wireless stations, if there are only 802.11b wireless
stations in the network, you can set the adapter to this mode.
When the adapter is set in Ad Hoc (Peer to
Peer) mode, you can designate the wireless connection mode for the
Ad Hoc network.
Though the adapter is compatible with both 802.11g and
802.11b wireless stations, if there are only 802.11b wireless stations
in the network, you can set the adapter to this mode.
If you have a mix of 802.11b and 802.11g wireless
stations in your network, it is recommended that the adapter be set
to this mode. This mode is also the default setting.
Though the adapter is compatible with both 802.11g and
802.11b wireless stations, if there are only 802.11g wireless stations
in the network, you can set the adapter to this mode.
If you have a mix of 802.11b and 802.11g wireless
stations in the network, it’s recommended that you enable the protection
mechanism, which can decrease the rate of data collisions between
802.11b and 802.11g wireless stations. When the protection mode is
enabled, the throughput of the adapter will be a little lower.
Depending on the status of the network, this automatically
disables/enables the protection mode.
Always enables the protection mode.
Always disables the protection mode.
CONFIGURATION
19
To Next Page
Loading...
