in this list. If the list is empty, that means that no WPS-enabled AP is
in the range.
The Wireless Provisioning Services Information Element
(WPS IE) makes it easier to connect to public Wi-Fi networks you’ve
not previously connected to. Your computer must have the WPS IE
update for Windows XP SP2 installed in order to use the function.
Select to activate.
Click to scan for WPS-enabled APs (perform a site survey).
Select a found WPS-enabled access point, then click
“Information” to display that AP’s details in a pop-up window.
The WPS PIN Code of this network adapter is required for
connection.
The service set identier of the connected WPS-
enabled access point.
The MAC address of connected WPS-enabled AP.
The authentication type of connected
WPS-enabled access point.
The encryption type of the connected WPS-
enabled access point
Click to show details of a selected WPS-enabled access point.
Click to connect to a WPS-enabled access point on the list.
Click to connect to next WPS-enabled access point on the list.
Click to disconnect from a connected WPS-enabled access
point. If there are other wireless access points in the prole, the last
CONFIGURATION
23
To Next Page
Loading...
