7
Chapter II: System and Network Setup
2-1 Installing the access point to your Network
Follow these instructions to build the network connection between
your new wireless access point and your computer’s network
devices:
1. Connect the access point to the router or switch/hub in your
network through the LAN port of the access point using Ethernet
cable.
2. Connect the A/C power adapter to the wall socket, then connect
it to the Power jack of the access point.
3. Check all LEDs on the front panel. The PWR LED should be
steadily on; the LAN LED should be on if the access point is
correctly connected to the ADSL modem, router or switch/hub. If
the PWR LED is not on, or if any LED you expect to be on isn’t,
recheck the cabling or refer to 4-2 Troubleshooting for possible
causes and solutions.
To Next Page
Loading...
Need help?
General
