23
2-4-1 AP Mode
This is the most common mode. When in AP mode, this access
point acts as a bridge between 802.11b/g/N wireless devices and a
wired Ethernet network, and exchanges data between them.
When you select AP, the following options will be displayed:
Here are descriptions of every setup item:
Band Select the wireless band you wish to use. By
selecting different band settings, you’ll be able
to allow or deny the wireless client of a certain
band.
If you select 2.4 GHz (B), 2.4 GHz (N) or 2.4
GHz (G), only wireless clients using the
wireless band you select (802.11b, 802.11 N or
802.11g) will be able to connect to this access
point.
If you select 2.4 GHz (B+G), then only wireless
clients using 802.11b and 802.11g bands will
be able to connect to this access point.
If you want to allow 802.11b, 802.11g and
802.11 N clients to connect to this access
point, select 2.4 GHz (B+G+N).
Main ESSID Input the ESSID (the name used to identify this
To Next Page
Loading...
