36
When you see this message, the settings you made are
successfully saved. Click “Continue” to go back to the previous
page and continue with other settings, or click “Apply” to restart the
wireless access point. Changes will take effect after about 30
seconds.
2-4-6 Universal Repeater
In this mode, the access point can act as a wireless repeater: It can
be Station and AP at the same time. It can use the Station function
to connect to a root AP and use the AP function to service all
wireless stations within its coverage.
NOTE: For Repeater Mode, this access point will
demodulate the received signal, check if this signal is noise
for the operating network, then have the signal modulated
and amplified again. The output power of this mode is the
same as that of WDS and normal AP mode.
To Next Page
Loading...
Need help?
General
