33
If you select 2.4 GHz (B+G), then only wireless
clients using 802.11b and 802.11g bands will
be able to connect to this access point.
If you want to allow 802.11b, 802.11g and
802.11 N clients to connect to this access
point, select 2.4 GHz (B+G+N).
Channel
Number
Select a channel number you wish to use. The
channel number must be the same as another
wireless access point you wish to connect to.
MAC address 1-4 Input the MAC address of the wireless access
point you wish to connect to.
Set Security Click to select an encryption mode for this
wireless link. A new popup window will appear.
Refer to Section 2-7 for detailed descriptions.
After you finish with the settings, click “Apply” and the following
message will be displayed:
When you see this message, the settings you made are
successfully saved. Click “Continue” to go back to the previous
page and continue with other setting, or click “Apply” to restart the
wireless access point. Changes will take effect after about 30
seconds.
To Next Page
Loading...
Need help?
General
