38
act as a station to connect to a root AP. You
should assign the SSID of the root AP here or
click “Select Site Survey” to choose a root AP.
Select Site
Survey
Click “Select Site Survey” and a “Wireless Site
Survey Table” will pop up. It will list all
available access points nearby. You can select
one access point in the table and the access
point will join the wireless LAN through this
access point. Go to Section 2-4-2-1 for more
information about the Wireless Site Survey
Table.
After you finish with the settings, click “Apply” and the following
message will be displayed:
When you see this message, the settings you made are
successfully saved. Click “Continue” to go back to the previous
page and continue with other settings, or click “Apply” to restart the
wireless access point. Changes will take effect after about 30
seconds.
To Next Page
Loading...
Need help?
General
