64
Inter-Tel
®
Model 8520 User Guide
MOVING ON
USING ACCOUNT CODES
If your telephone system is programmed to use the Station Message Detail Recording
(SMDR) feature, you might be required to enter account codes when you place a call.
These codes add information to telephone record reports that the system will periodi-
cally print.
There are three types of account codes:
• Standard account codes are automatically entered into the SMDR report when-
ever you place a call.
• Forced account codes must be dialed before you can place an outside call.
• Optional account codes can be entered at any time during a call.
NOTE: Your system administrator can tell you which types of account codes are used
on your telephone system.
To enter an optional account code:
1. Press and dial .
2. Enter the optional account code. If the account code is not immediately
accepted, press .
To set an account code for all calls placed from your endpoint:
Dial
and then the account code. If the account code is not immediately
accepted, press . This code will be used for all calls made from your endpoint until
it is disabled.
To disable the code:
Dial
and press .
3 9 0
#
3 9
1
#
3 9
1
#
8520.book Page 64 Friday, December 2, 2005 2:59 PM
To Next Page
Loading...
