D-0121151-B – 2018/11
AD528 - Instructions for Use - EN Page 42
To ensure compliance with the EMC requirements as specified in IEC 60601-1-2, it is essential to use
only the following accessories:
Monitor Headset w. microphone
Talk Back Microphone Clip-On
Conformance to the EMC requirements as specified in IEC 60601-1-2 is ensured if the cable types
and cable lengths are as specified below:
Monitor Headset
w. microphone
Talk Back Microphone Clip-On
Portable and mobile RF communications equipment can affect the AD528™. Install and operate the
AD528™ according to the EMC information presented in this chapter.
The AD528™ has been tested for EMC emissions and immunity as a standalone instrument. Do not use the
AD528™ adjacent to or stacked with other electronic equipment. If adjacent or stacked use is necessary, the
user should verify normal operation in the configuration.
The use of accessories, transducers and cables other than those specified, with the exception of servicing
parts sold by Interacoustics as replacement parts for internal components, may result in increased
EMISSIONS or decreased IMMUNITY of the device.
Anyone connecting additional equipment is responsible for making sure the system complies with the IEC
60601-1-2 standard.
Guidance and manufacturer’s declaration - electromagnetic emissions
The AD528™ is intended for use in the electromagnetic environment specified below. The
customer or the user of the AD528™ should assure that it is used in such an environment.
Electromagnetic environment - guidance
CISPR 11
The AD528™ uses RF energy only for its internal
function.
Therefore, its RF emissions are very low and are not
likely to cause any interference in nearby electronic
The AD528™ is suitable for use in all commercial,
industrial, business, and residential environments.
Harmonic emissions
IEC 61000-3-2
flicker emissions
To Next Page
Loading...
