15
o
Coil Nailer
Drives Plastic Sheet Nails (1¼" to 2½" / 32 to 65mm)
or Wire Weld Nails (1¾" to 2½" / 45 to 65mm)
Model No. CN565-15
Item No. 65555
12
Interchange Brands Operator’s Manual
Operating The Nailer
DANGER: Operators and others in work area must wear safety glasses with side
shields that conform to ANSI Z87.1 specifications.
Read and understand METHODS OF OPERATION below.
Both single fire and bump fire are available on this nailer. Adjust the button on the
trigger.
Operating Instructions
Read section titled “SAFETY INSTRUCTIONS.”
BEFORE OPERATION
1. Wear safety glasses or goggles with side shields.
2. Do not connect the air supply.
3. Inspect screws and tighten if necessary.
4. Check operation of the contact arm and trigger to make sure they are moving
smoothly.
5. Connect the air supply.
6. Check the air-leakage. (The tool must not have any air-leakage.)
7. Hold the tool with finger off the trigger, then push the contact arm against the
work piece. (The tool must not operate).
8. Hold the tool with contact arm away from work piece and pull the trigger. (The
tool must not operate.)
9. Disconnect the air supply.
OPERATION
Danger to the eyes exists due to the possibility of flying fasteners and debris when
operating the nailer. To guard against these hazards always wear safety glasses with
side shields to protect both the front and sides. Make sure others in the work area
wear safety glasses, too.
Eye protection equipment must conform to the requirements of American National
Standards Institute, ANSI Z87.1.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American National
Standards Institute, ANSI Z87.1 and provide both frontal and side protection.
The employer is responsible to enforce the use of eye protection equipment by the tool
operator and all other personnel in the work area.
NOTE: Spectacles and face shields without the side shields do not provide adequate
protection.
Keep hands and body away from the discharge outlet when driving the fasteners to
prevent striking the hands or body by mistake.
To Next Page
Loading...