15
o
Coil Nailer
Drives Plastic Sheet Nails (1¼" to 2½" / 32 to 65mm)
or Wire Weld Nails (1¾" to 2½" / 45 to 65mm)
Model No. CN565-15
Item No. 65555
4
Interchange Brands Operator’s Manual
Nail Length Shank Diameter Head Diameter
Tool Information
Nailer Specifications: CN565-15 Coil Nailer
Tool Dimensions -
Length x Height x Width
12.56" x 10.75" x 5.12"
﹙319mm x 273mm x 130mm﹚
Weight
5.50 lbs. ﹙2.50 kgs.﹚ Aluminum Body
5.17 lbs. ﹙2.35 kgs.﹚ Magnesium Body
Magazine Capacity Wire 250 to 400 Nails; Plastic 200 Nails
Recommended Operating Pressure 70 to 120 psi / 5 to 8.5 kgs.
Applications
General Construction Applications including: Siding, Sheathing, Fencing, Decking,
Furring and Exterior Deck and Trim and Strapping.
Nail Specifications
WARNING: Be sure to use only the genuine nails recommended for the CN565-15.
The use of any other nails can result in tool malfunction, leading to serious injuries.
Only the nail sizes shown in the table below can be driven with this nailer.
FASTENERS:
Wire Welded Nail Length 1-3/4" to 2-1/2" / 45 to 65mm
Plastic Sheet Collated Nail Length 1-1/4" to 2-1/2" / 32 to 65mm
Shank Diameter 0.092" to 0.099" / 2.3 to 2.5mm
Head Diameter 0.197" to 0.236" / 5.0 to 6.0mm
Shank Type Smooth, Ring, Screw
DIMENSIONS OF FASTENERS:
15˚ Coil Nails - Flat, Plastic Sheet and Wire Weld Collated
-
0.092" to 0.099"
2.3mm to 2.5mm
2-1/2"
65mm
0.197" to 0.236"
5.0mm to 6.0mm
Plastic
Sheet
1-1/4"
32mm
Wire
Weld
1-3/4"
45mm
To Next Page
Loading...