Interface BSC4 User Manual

BSC4 Operating Manual
Interface Inc. ● 7401 East Butherus Drive, Scottsdale, Arizona 85260 USA ● Phone 480.948.5555 ● Fax 480.948.1924
www.interfaceforce.com ● Email: contact@interfaceforce.com ● 800.947.5598
Document Number 15-183 Rev B Page 52 of 74
E. Trigger Send value
i. Actual Values
ii. Maximum Values
iii. Minimum Values
iv. Mean Values
F. GP Output – “General Purpose” Output
G. Threshold Switch
4.3.3. Threshold switch Mode – Only Activated if Threshold Switch is selected in I/O type.
A. Hysteresis switch (normal) – Digital output becomes active if measuring value of
corresponding channel is above ON-threshold. It becomes inactive if measuring value of
corresponding channel is blow OFF-threshold.
B. Window comparator – Digital output becomes active if measuring value of corresponding
channel is between upper and lower threshold, otherwise inactive.
4.3.4. Line Inverted
A. Not inverted – Active level is logical high = 5V. Inactive logical low is 0V.
B. Inverted – Active level is logical low – 0V. Inactive logical high is 5V.
4.3.5. Default output level – Level which digital I/O will output by default. That applies to all DIO
output types after power-on, before a set output condition occurs.
A. E.g. set output level command if GP output type.

Interface BSC4 Specifications

General

Brand	Interface
Model	BSC4
Category	Amplifier
Language	English