BSC4 Operating Manual
Interface Inc. ● 7401 East Butherus Drive, Scottsdale, Arizona 85260 USA ● Phone 480.948.5555 ● Fax 480.948.1924
www.interfaceforce.com ● Email: contact@interfaceforce.com ● 800.947.5598
Document Number 15-183 Rev B Page 27 of 74
Adding a Single Channel
1. Run BlueDAQ from the start menu. After the program launches click “ADD CHANNEL”
FIGURE 17 - ADD CHANNEL
2. In the Add Channel dialog box
2.1. Click Devicetype drop-down and select BSC4, BSC8, BX8, or BSC2 (9330)
2.2. Click the Device dropdown box and select the device, select the COM Port (See Device
Manager if unknown) and open the correct amount of input channels (First = 1 and Last =
total # of channels for device). For Model 9330, you will not be allowed to change the
number of channels. If using the BSC8/BX8 with a 6-axis sensor then stop after opening 6
channels and proceed to step 6.12.
To Next Page
Loading...