BSC4 Operating Manual
Interface Inc. ● 7401 East Butherus Drive, Scottsdale, Arizona 85260 USA ● Phone 480.948.5555 ● Fax 480.948.1924
www.interfaceforce.com ● Email: contact@interfaceforce.com ● 800.947.5598
Document Number 15-183 Rev B Page 21 of 74
BlueDAQ Software Installation (Compatible with BSC4D)
1. Please follow these instructions carefully. DO NOT connect the amplifier to the PC until
instructed to do so. The BlueDAQ PC software is included on a USB Flash Drive with the amplifier
or can be downloaded from www.interfaceforce.com
2. Install the software by double-clicking the “setup.exe” file located in the BlueDAQ folder. You may
need to “Extract” the contents of the folder first if you downloaded it from the website. Follow the
instructions for installation. Once the software completes installation you MUST restart your
computer.
3. Attach the amplifier to the PC using the supplied USB A-B cable. BSC4, BSC8 and BX8 drivers
were installed with the BlueDAQ software and Windows will automatically load them. BSC8D/BX8
must be powered ON using supplied power cable and power switch. 9330 drivers must be
installed as described below.
4. When the device is connected in Communication mode for the first time, Windows will ask for a
driver directory. The installation process is described below. The driver is located on the USB
Flash drive supplied with the 9330. The Flash drive MUST be connected to the PC or the files
copied to the PC before connecting the 9330 to the PC.
5. Enable USB Communication mode. To do this, click the MODE button of the measuring amplifier
and select USBmode: Comm in the logger menu.
To Next Page
Loading...
Need help?
General