Interlogix Advisor Advanced ATS1000A-SM - Options Affected by Other Regulations; ACPO Policy; INCERT Policy

Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 239
Options affected by other regulations
ACPO policy
Required settings are all EN 50131 Grade 2 settings with the following
modifications:
• 5.n.7 Entry alarms, Delayed
• 8.2.4 Engineer reset, tamper enabled
• 8.7.7 Alarm confirm:
- AB mode, enabled for all relevant areas
- AB time, 30 min minimum, 60 min maximum
- EE Confirm, enabled
- TA confirm, enabled
Note: ACPO policy allows a higher level manager to become a level 3 user. Also,
level 3 user menu access may be allowed without level 2 user authorization if it is
provided by appropriate written agreement from the customer.
INCERT policy
Required settings:
• Isolate for End Users option disabled in 3.2.n.5 User group options
• Full Set/Part Set/Unset/Forced Set for Installer disabled in 3.2.n.5 User group
options
• 8.2.4 Engineer reset, tamper enabled
• 8.4.1 RTS options, all enabled except FTC, Pending Alarms, and Zone
technical alarm, that are optional
• RTS for Battery Fault enabled in 8.4.1 RTS options
• Inhibit for Battery Fault disabled in 8.4.2 Inhibit includes
• PIN length should be 6 digits minimum. See also “8.7.5 PIN length”.