Concord 4 User Manual 27
undesired partition numbers by pressing the corresponding button. The
numbers disappear from the display.
4. Press *, 00, # to exit the programming menus.
Time and date
Although the installer usually sets the time and date at the time of installation,
you can change it if necessary.
To set the system time:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. Press 020.
3. Enter the correct time in 24-hour format, then press #. For example, if the
current time is 7:23 a.m., press 0723, #, or if the current time is 4:20 p.m.,
press 1620, #.
4. Press *, 00, # to exit the programming menus.
To set the system date:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. Press 021.
3. Enter the current date as six digits (mm/dd/yy) then press #. For example, if
the current date is July 14, 2010, press 071410.
4. Press *, 00, # to exit the programming menus.
System sounds
You can adjust the touchpad beeps and the system status voice volume.
Touchpad beeps (fixed display touchpad only)
The frequency or pitch of chime and trouble beeps from each fixed display
touchpad can be adjusted individually to a more desirable or distinct tone. Chime
and trouble beep tones sound using the default frequency during, or within 15
seconds of, any button activity at that specific touchpad. To change status tone
pitch:
1. Press and hold * + 0 until you hear a steady tone, then release the buttons.
2. Press and hold 1 to lower the pitch or press and hold 2 to raise the pitch.
To Next Page
Loading...
