19
P/N 466-5308 • REV A • ISS 09MAY17 ©2017 United Technologies Corporation
9.1 Set up a Wireless Detector Network (Wireless
Interconnect)
1.
Remove all wireless detectors from their packaging (suggest using a table and activating all detectors in a group).
2. Power on all detectors by attaching the detectors onto the mounting bracket (trim plate) to activate the
battery, or by carefully turning the red activation wheel with a screwdriver. See Figure 4.
•
The GREEN LED will fade on and off once, then the RED LED will begin fading on/off every 3 seconds.
NOTE: If no further steps are taken within 15 minutes of initial power up, the wireless function will turn
off. The detector will then perform as a single station detector.
WIRELESS
These models have wireless detector interconnect capability. When one interconnected detector sounds an
alarm, all other compatible wireless detectors in the wireless detector network will alarm.
A maximum of 24 compatible devices may be interconnected in a multiple station arrangement in conjunc-
tion with a compatible panel.
This detector is not designed to be interconnected with other manufacturer’s products, unless otherwise
specified.
WIRELESS INTERCONNECT MODEL COMPATIBILITY
The following Interlogix models can be interconnected using wireless interconnect:
• SDX-135Z, CDX-135Z
• Maximum distance between wireless interconnect models is 300 feet in open air.
Figure 4
To Next Page
Loading...
