IC: 7145A-25609702
This device complies with FCC Part 15 and Industry Canada license exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire
de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
RF EXPOSURE
All transmitters regulated by IC must comply with RF exposure requirements listed in RSS-102 - Radio
Frequency (RF) Exposure Compliance of Radiocommunication Apparatus (All Frequency Bands). Currently
this device is approved for use for when 20cm can be maintained between the antenna and users. Specific
Absorption Rate (SAR) evaluation is required if the separation distance between the user and/or bystander
and the antenna and/or radiating element of the device is less than or equal to 20 cm. Exceptions are listed
in RSS-102. Note that integration < 20 cm will require further certification with IC such as a Multiple listing
and Class IV Permissive Change application.
Tous les émetteurs régulés par Industrie Canada doivent ętre conformes à la notice RSS-102 d’Industrie
Canada concernant la Conformité des appareils de radiocommunication aux limites d’exposition humaine
aux radiofréquences (toutes bandes de fréquences). Ce produit est ainsi approuvé pour une utilisation d’au
moins 20 cm entre l’antenne et toute personne à proximité. Une évaluation du Débit d’Absorption Spécifique
(DAS) est requise si cette distance de séparation est inférieure ou égale à 20 cm. Des exceptions sont
toutefois répertoriés dans la notice RSS-102. Mais il est souligné que l’utilisation d’un dispositif à moins de
20 cm nécessite une certification supplémentaire avec Industrie Canada, comme un complément d’infor-
mation et l’application à la notice de Changement Permissif de Classe IV.
If this equipment does cause harmful interference to radio or television reception, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by UTC Fire and Security could void the user’s authority
to operate the equipment.
WARNING: ANY CHANGES OR MODIFICATIONS MADE TO THIS PRODUCT NOT EXPRESSLY
AUTHORIZED BY THE MANUFACTURER COULD VOID THE USER’S RIGHT TO OPERATE THIS
DEVICE.
To Next Page
Loading...
