Interlogix TVD-5301 - Camera Configuration; System, Time, and Maintenance Settings

TruVision Series 3 IP Camera FW3.1 Configuration Manual 11
Camera configuration
This chapter explains how to configure the cameras through a web browser.
Once the camera hardware has been installed, configure the camera’s settings
through the web browser. You must have administrator rights in order to
configure the cameras over the internet.
The camera web browser lets you configure the camera remotely using your PC.
Web browser options may vary depending on camera model.
There are two main folders in the configuration panel:
 Local configuration
 Configuration
Configuration menu overview
Use the Configuration panel to configure the server, network, camera, alarms,
users, transactions and other parameters such as upgrading the firmware. See
Figure 2 and Table 2 below for descriptions of the configuration folders available.
Figure 2: Configuration panel (Device Information tab selected)
Table 2: Overview of the Configuration panel
Configuration folders Description
1. System Defines the camera name and number. Displays basic information on
the device including SN and the current firmware version
, time settings,
maintenance, and serial port parameters. See “System time” on page
13, “Restore default settings” on page 58, and “Upgrade firmware” on
page 59 for more information.