Interlogix TVD-5301 - Restore Default Settings

58 TruVision Series 3 IP Camera FW3.1 Configuration Manual
2. Select the IP Address Filter tab.
3. Check the Enable IP Address Filter check box.
4. Select the type of IP Address Filter in the drop-down list, Forbidden or
Allowed.
5. Click Add to add an IP address.
6. Click Modify or Delete to modify or delete the selected IP address.
7. Click Clear to delete all the IP addrsses.
8. Click Save to save the changes.
Defining the security service
The camera provides a security service by allowing you to enable remote login
and to improve data communication security.
To enable the illegal login lock:
1. Click Configuration > Security > Security Service.
2. Check the Enable Illegal Login Lock check box
3. Click Save to save the changes.
Note:
1. The IP address will be locked if the admin user performs 7 failed user
name/password attempts (10 attempts for the operator/user).
2. If the IP address is locked, you can try to login the device after 5 minutes.
To define SSH:
1. Click Configuration > Security > Security Service.
2. Check the Enable SSH check box.
3. Click Save to save the changes.
Restore default settings
Use the Default menu to restore default settings to the camera. There are two
options available:
 Restore: Restore all the parameters, except the IP parameters, to the default
settings.
 Default: Restore all the parameters to the default settings.
Note: If the video standard is changed, it will not be restored to its original setting
when Restore or Default is used.