The UPnP (Universal Plug and Play) protocol allows devices to connect
seamlessly and to simplify the implementation of networks in the home and
corporate environments. With the function enabled, you do not need to
configure the port mapping for each port, and the camera is connected to the
Wide Area Network (WAN) via the router.
Enable and set the friendly name detected.
9.
Specifies authentication of the web site and its associated web server, which
protects against Man-in-the-middle attacks.
To define the TCP/IP parameters:
1. Click Configuration > Network > TCP/IP.
2. Configure the NIC settings, including the NIC Type, IPv4 settings, IPv6
settings, MTU settings, and Multicast Address.
3. If the DHCP server is available, check DHCP.
4. If the DNS server settings are required for some applications (e.g., sending
email), you should configure the Preferred DNS Server or Alternate DNS
Server.
5. Click Save to save changes.
To define the port parameters:
1. Click Configuration > Network > Port.
To Next Page
Loading...
