Interlogix TVD-5303 - Local Configuration

12 TruVision Series 3 IP Camera FW3.1 Configuration Manual
Configuration folders Description
2.
Network
Defines the network parameters required to access the camera over
the internet. See “Network settings” on page 15 for more information.
3.
Video/Audio
Defines recording parameters. See “Recording parameters” on page
26 for more information.
4.
Image
Defines the image parameters, OSD settings, overlay text, and privacy
mask. See “Video image” on page 29, “OSD (On Screen Display)” on
page 33, “Overlay text” on page 34, and “Privacy masks” on page 35
for more information.
5.
Security
Defines who can use the camera, their passwords and access
privileges, RTSP authentication, IP address filter, and SSH access.
See “Camera management” on page 54 for more information.
6.
Basic
Events Defines motion detection, tamper-proof, alarm input/output, and
exception. See “Motion detection alarms” on page 36, “Tamper-proof
alarms” on page 40, and “Exception alarms” on page 40.
7.
Smart Event
Defines cross line and intrusion detection.
8.
Storage
Defines recording schedule, storage management, NAS configuration,
and Snapshot parameters. See “NAS settings” on page 49, “Storage
devices” on page 50, and “Recording schedule” on page 50 for more
information, and “Snapshot parameters” on page 47 for more
information.
Local configuration
Use the Local menu to manage the protocol type, live view performance and
local storage paths. In the Configuration panel, click Local Configuration to
display the local configuration window. See Figure 3 and Table 3 below for
descriptions of the different menu parameters.
Figure 3: Example of a configuration window (Local configuration shown)