TruVision Series 3 IP Camera FW3.1 Configuration Manual 47
5. Click Edit to set the arming schedule for the alarm input. See “Motion
detection alarms” on page 36 for more information.
6. Configure the linkage action.
7. Click Save to save changes.
Snapshot parameters
You can configure scheduled snapshots and event-triggered snapshots. The
captured snapshots can be stored in the SD card (if supported) or the NAS. You
can also upload the snapshots to an FTP server.
You can set up the format, resolution and quality of the snapshots. The quality
can below, medium, or high.
You must enable the option Enable Timing Snapshot if you want snapshots to
be uploaded to the FTP. If you have configured the FTP settings and checked
Upload Type in the Network > FTP tab, the snapshots will not be uploaded to
the FTP if the Enable Timing Snapshot option is disabled.
You must enable the option Enable Event-Triggered Snapshot if you want
snapshots to be uploaded to the FTP and NAS when motion detection or an
alarm input is triggered. If you have configured the FTP settings and checked
Upload Type in the Network > FTP tab for motion detection or an alarm input,
the snapshots will not be uploaded to the FTP if this option is disabled.
To Next Page
Loading...
