36 TruVision Series 3 IP Camera FW3.1 Configuration Manual
Figure 8: Privacy mask menu
To add privacy mask area:
1. Click Configuration > Image > Privacy Mask.
2. Check Enable Privacy Mask.
3. Click Draw Area.
4. Click and drag the mouse in the live video window to draw the mask area.
Note: You are allowed to draw up to four areas on the same image.
5. Click Stop Drawing to finish drawing, or click Clear All to clear all of the
areas you set without saving them.
6. Click Save to save changes.
Motion detection alarms
You can define motion detection alarms. A motion detection alarm refers to an
alarm triggered when the camera detects motion. However, the motion alarm is
only triggered if it occurs during a programmed time schedule.
Select the level of sensitivity to motion as well as the target size so that only
objects that could be of interest can trigger a motion recording. For example, the
motion recording is triggered by the movement of a person but not that of a cat.
You can define the area on screen where the motion is detected, the level of
sensitivity to motion, the schedule when the camera is sensitive to detecting
motion as well as which methods are used to alert you to a motion detection
alarm.
You can also enable dynamic analysis for motion. When there is motion, the area
will be highlighted as green.
To Next Page
Loading...
