. Initializes the lens
Note:
1. To do pan/tilt movement using the direction buttons, the camera connected to
the network must support RS-485 and a pan/tilt unit must be installed in the
camera. Please properly set the PTZ parameters on the RS-485 Settings
page referring to Defining RS-485 settings
2. To control the lens, such as zoom or focus, the camera must support auto
focus.
To set a preset:
1. Select a preset number from the preset list.
2. Use the PTZ directional buttons to move the camera to the desired position.
3. Click to finish the setting of the current preset.
4. You can click to delete the preset.
To call a preset:
1. Select a defined preset from the list.
2. Click to call the preset.
Using preset tours
A preset tour is a memorized series of preset functions. The camera stays at a
step for a set dwell time before moving on to the next step. The steps are defined
by presets. A preset tour can be configured with up to 32 presets.
You can configure up to eight preset tours.
To Next Page
Loading...
