TruVision Series 3 IP Camera FW3.1 Configuration Manual 69
To set a preset tour:
1. In the PTZ control panel, click to enter the tour settings interface.
2. Select a preset tour number from the drop-down list.
3. Click to enter the adding interface of preset.
4. Configure the preset number, preset tour time and preset tour speed.
Preset Tour Duration:
The dwell time. The length of time in seconds for which a
camera stays at a preset before moving to the next preset.
Preset Tour Speed: The speed the camera moves from one preset to another.
5. Click OK to save a preset into the preset tour.
6. Repeat the steps from 3 to 5 to add more presets.
7. Click to save all the preset tour settings.
To call a preset tour:
In the PTZ control panel, select a defined preset tour from the drop-down list and
click to call the preset tour.
To Next Page
Loading...
