TruVision Series 3 IP Camera FW3.1 Configuration Manual 7
Activating the camera
When you first start up the camera, the Activation window appears. You must
define a high-security admin password before you can access the camera. There
is no default password provided.
You can activate a password via a web browser and via TruVision Device
Manager (included on the CD to find the IP address of the camera).
To activate the camera via the web browser:
1. Power on the camera and connect the camera to the network.
2. Input the IP address into the address bar of the web browser, and click Enter
to enter the activation interface.
Notes:
The default IP address of the camera is 192.168.1.70.
For the camera to enable DHCP by default, you must activate the camera
via TruVision Device Manager. Please refer to the following section, “To
activate the camera via TruVision Device Manager” below.
3. Enter the password in the password field.
Note: A valid password range must be between 8 and 16 characters. You can
use a combination of numbers, lower and upper case letters, and special
characters : _ - , . * & @ / $ ? Space. The password must contain characters
from at least two of these groups. We also recommend that you reset your
password regularly. For high security systems, it is particularly recommended
to reset the password monthly or weekly for better protection.
4. Confirm the password.
5. Click OK to save the password and enter the live view interface.
To activate the camera via TruVision Device Manager:
1. Run the TruVision Device Manager to search for online devices.
2. Check the device status from the device list, and select the inactive device.
To Next Page
Loading...
