UltraView PTZ
User Manual
4
Programming shortcuts
This section lists the keypad programming shortcuts for presets and tours. For detailed instructions, refer to the
KTD-405/KTD-405A/KTD-405-2D Controller Keypad User Manual.
Presets:
• To store: Position the camera. Press the store key and then enter the preset number. Press store again.
• To call up: Press find and enter the preset number.
Shadow Tours:
• To store: Press and hold the esc key and then press the tour key. Then press the + side of the zoom,
focus, or iris key to start recording a shadow tour. Athe end of the shadow tour, press esc.
Accessing programming menus
To access the programming menus using the keys on a KTD-405 keypad, do the following:
1. Switch the keypad to the camera site you want to program.
2. Press and hold the set key until Enter programming code displays.
3. At the code entry display, enter the programming code 9, 5, 1. Then press the seq button.
4. At the first menu display, press 3.
5. At the Enter camera site number screen, enter the site number of the camera you wish to program.
At this point, you have access to the UltraView PTZ programming menus. For more information on the
programming menus, see Menu navigation on page 5.
Note: If you are prompted to enter a password, refer to Passwords on page 33 for the default pass code key.
To Next Page
Loading...
