Chapter 1
Programming
33
To set alarm reporting, do the following:
To set a relay, do the following:
System startup
The system startup menu allows you to enable, disable, and change passwords, as well as set the installation
date, set an action on power-up, and set position reporting.
Passwords
To change the password from the default of 3477, do the following:
1. Select 2 from the alarms and relays menu. The Alarm
reporting menu displays (Figure 68).
2. Enter selection 1 to disable (the default) or 2 to enable.
Figure 68.Alarm reporting menu
1. Select 2 from the Alarms and relays menu. The Relay
programming menu displays (Figure 69).
2. Use the joystick to select an alarm number 01 through 04
and press iris+ to choose a relay.
3. Press iris+ again to set a delay time for the relay.
Figure 69.Relay programming menu
1. From Program select menu 2, select System startup. The
Password protection menu displays (Figure 70).
Figure 70.Password protection
To Next Page
Loading...
