Chapter 1
Programming
27
Tours
Tours 1, 2, 5, and 6 in the PTZ programming menu are ShadowTours. Tours 3, 4, 7, and 8 in the PTZ
programming menu are preset tours.
ShadowTours
UltraView PTZ cameras have ShadowTour capability. A ShadowTour is a tour that a PTZ camera “learns” by
recording up to five minutes of manual PTZ operation. Use a keypad to manually direct your camera through
the desired PTZ movements, and the camera stores in memory the movements you performed. This recorded
tour can be replayed at any time.
To program a new ShadowTour, do the do the following:
To edit a previously programmed ShadowTour, do the following:
1. From the Program select menu, select option 5.
2. From the PTZ tour programming menu, pan right with
the joystick to advance to the menu that displays
ShadowTours (Figure 56).
3. Select the tour you want to create by pressing Iris+ to
enter the tour programming menu.
Figure 56.PTZ tour programming (ShadowTours)
4. Select 1 to choose New tour (Figure 57).
5. Press iris + to start the timer.
6. Move the PTZ camera through the desired movements.
7. Press iris + to exit back to the PTZ tour programming
menu.
8. Repeat steps 2 through 8 for more ShadowTour
programming. Otherwise, press iris- until you exit back
to the Program select menu.
Figure 57.ShadowTour programming menu
1. From the Program select menu, select option 5.
2. From the PTZ tour programming menu, pan right with
the joystick to advance to the menu that displays
ShadowTours (Figure 56 on page 27).
3. Select the tour you want to edit.
To Next Page
Loading...
